I'm making a grinder for sharpening lawnmower blades, and as part of it, making an axle for the grinding wheel.
And since it's being driven via a pulley, I'm putting in a keyway for the pulley, and since I don't have a mill, I decided to make a jig so I could use my lathe to do it. I worked off this video:
Pretty straightforward. Here's the jig:
View attachment 124295
And after milling it:
View attachment 124296
Did a reasonably good job,...
Today's Lesson: Making A Jig...
And since it's being driven via a pulley, I'm putting in a keyway for the pulley, and since I don't have a mill, I decided to make a jig so I could use my lathe to do it. I worked off this video:
Pretty straightforward. Here's the jig:
View attachment 124295
And after milling it:
View attachment 124296
Did a reasonably good job,...
Today's Lesson: Making A Jig...