Stripped a couple of rack mount computer servers down to just the case & turned them into drawers for my PM1127 lathe stand. This one is 4 rack units (RU), have another that's 2 RU. The rails & slides were salvaged from an enclosure at our office that was no longer needed. I used to top to the servers to cut face plates for the drawers. As you can see, these will hold several hundred pounds each.
Once I get the drawers are installed, I plan to use the material from the lathe's shipping...
Recycled Computer Products In Shop
Once I get the drawers are installed, I plan to use the material from the lathe's shipping...
Recycled Computer Products In Shop