I've been experimenting with bending square hollow section for a small project but not having much luck. I welded a nice radius and a couple of stops to some plate as a jig, heated the section and tried to bend it (like I would do for a solid bar) but it just pinched and buckled on the sides.
I was planning to use them as the 'shelves' (I'm sure there is a proper word but can't think of it) for a steel stock rack and just wanting to put a small kick in the end to stop any round section...
Bending Square Hollow Section
I was planning to use them as the 'shelves' (I'm sure there is a proper word but can't think of it) for a steel stock rack and just wanting to put a small kick in the end to stop any round section...
Bending Square Hollow Section