1340gt Qctp Tool Holder Hanger

I made up a hanger for the quick change tool holder to mount on the PM 1340GT. I have seen a few designs like the one I did from this site as well as others. I'd say I copied Mikes (zmotorsports) to some degree but with a little twist. I wanted to go with something other than unistrut. I ended up using some 1.5 x 1.5 inch 80/20 t-slot aluminum I had sitting around the shop.
View attachment 126982

I then used some scrap polycarbonate to make "holders" that attached to the 80/20 with 2...

1340gt Qctp Tool Holder Hanger