Just lately I have had cause to question the accuracy of my coaxial indicator. so as a test I held the stem in the lathe 3 jaw. and placed the end of the short feeler ( the most accurate ) against the tool post zeroed the indicator -- the cross slide dial and the digital read out. fed in the cros slide to give one division on the Co ax -- said to be .0005" offset,
And the dial and digital read out read about .0025" this did not look good. so to get better accuracy I went to 10 divisions...
Coaxial Indicator Problem
And the dial and digital read out read about .0025" this did not look good. so to get better accuracy I went to 10 divisions...
Coaxial Indicator Problem