Quantcast
Channel: The Hobby-Machinist
Viewing all articles
Browse latest Browse all 83214

End Mill Sharpening Attempt

$
0
0
Recently, I was in the TechShop, which is a shared machine membership facility. Usually, there are some end mills in the mill box. They are often not in very good shape, but they do work a little bit. This time, there were only two. One had the end snapped off. It would still work for side milling. The other just had a burned up end. I thought it might be fun to try to see if I could sharpen the end mill by hand on the grinder. There was no dresser available, so the right edge of the...

End Mill Sharpening Attempt

Viewing all articles
Browse latest Browse all 83214

Trending Articles