Hi All - I'm making a part and have a need to mill a couple of slots into a piece of CRS. The feature I'm asking about is circled in pic below...
![[IMG]]()
The slot is .125" deep and .125" tall.
I was thinking I'd have to buy a slot-cutting end mill, but when I go to look for them, I can't seem to find anything appropriate. I can find 3mm and 4mm metric cutters. 4mm is too tall, but I guess a 3mm could...
Question On Milling A Slot
![[IMG]](http://i1124.photobucket.com/albums/l568/kizmit99/Lower%20TopPlate_zps1yzjtouw.jpg)
The slot is .125" deep and .125" tall.
I was thinking I'd have to buy a slot-cutting end mill, but when I go to look for them, I can't seem to find anything appropriate. I can find 3mm and 4mm metric cutters. 4mm is too tall, but I guess a 3mm could...
Question On Milling A Slot