look toward the bottom of this page: (ENCO catalog page 42)
http://www.use-enco.com/CGI/INPDFF?PMPAGE=42&PMITEM=337-3195
I was all set to order carbide drills and seen they are not recommended for use in steel. Why?
I've ordered what I'm think is the same product - carbide jobber length drills - from McMaster Carr. They worked fine.
Anyway, I'd like a set of carbide drills to use in steel, especially for when it might have hardened sections.
Suggestions?
http://www.use-enco.com/CGI/INPDFF?PMPAGE=42&PMITEM=337-3195
I was all set to order carbide drills and seen they are not recommended for use in steel. Why?
I've ordered what I'm think is the same product - carbide jobber length drills - from McMaster Carr. They worked fine.
Anyway, I'd like a set of carbide drills to use in steel, especially for when it might have hardened sections.
Suggestions?
