Quantcast
Channel: The Hobby-Machinist
Viewing all articles
Browse latest Browse all 83326

Help Needed: Small Part For Milling. Proper Hold-down/how To Q!

$
0
0
Hi everyone. This is the first pair of small part that I need to mill down (preffered) or grind.
They go into the bottom groove of a new mill vise for the hobby mill w/ .5 T-slots These are sized for the 5/8 larger table slots.
My problem:
There is simply not much to "bite" onto in the vise as I need to mill down until 1/32 off the vise top. (pics below).

I need to remove .085 from each long side. They are in there and very tight. I took a mallet to them to see if I could pop one...

Help Needed: Small Part For Milling. Proper Hold-down/how To Q!

Viewing all articles
Browse latest Browse all 83326

Trending Articles