The Hobby-machinist Die Filer

Time for a new project. I will be building a Die Filer. This will be a larger one than most of you are used to seeing. The Table will measure 14.000 X 14.000. It will be 16.000 tall. A "Scotch Yoke" will be utilized to convert the circular motion to linear motion of the file. The Table will also tilt forward 45 degrees.

Here are a couple of pix of the Table Trunnions ready to be cut. They must be the same so they are bolted together. The 4 inch diameter piece bolted to that is to mount...

The Hobby-machinist Die Filer