I've done some reading and ran a simulation in Mach 3 but to be sure before I unnecessarily waste material I thought I would run it past the brain trust. How do I set up work offsets and apply them to my gcode?
My first part is located at X=0, Y=0 and Z=0. Y and Z do not change for subsequent parts. The X axis work offset for the second part is -5.750 and the offset for the third part is -11.500. I've gone to the Offsets screen and clicked on the Save Work Offsets button. In the Work...
Mach 3 Work Offset
My first part is located at X=0, Y=0 and Z=0. Y and Z do not change for subsequent parts. The X axis work offset for the second part is -5.750 and the offset for the third part is -11.500. I've gone to the Offsets screen and clicked on the Save Work Offsets button. In the Work...
Mach 3 Work Offset