I was going to post a question about making a large washer -- 2.625 OD, 1.06 ID, about .375 thick -- until I realized I could buy almost exactly what I needed from Fastenal .. problem solved. The tolerances are pretty loose in this whole problem -- 2.5" or 2.75" OD would be OK, as would a 1.125" ID, or .400 thickness, etc.
But since I was going to ask about this sort of thing anyhow, I might as well proceed.
My plan was to make this from some flat stock: Mark a center and a 2.625"...
Making One Washer
But since I was going to ask about this sort of thing anyhow, I might as well proceed.
My plan was to make this from some flat stock: Mark a center and a 2.625"...
Making One Washer