Quantcast
Channel: The Hobby-Machinist
Viewing all articles
Browse latest Browse all 83311

How To Approach This Job

$
0
0
I have a simple job to do but very little machining experience. I need to make some washers, 8 at 2" and 1/4 thick with a 7/16 hole and 8 at 1.25" and 3/16 thick with a 3/8 hole. I have a 1 ft piece of 2" hot rolled steel. I have thought of 3 ways of doing this.

1. Face off. Drill an undersized hole. Set up the tail stock. Part off the 1/4 thick pieces. Drill to 7/16 on the drill press. For the smaller washers then turn down to 1.25 diameter, part off the pieces and then drill to...

How To Approach This Job

Viewing all articles
Browse latest Browse all 83311

Trending Articles