Well I secured my small rotary table on my mill and tried a cut. I was turning pretty slow and steady but, part and table top kept jumping back as I went forward. I don't know if there is any backlash adjustment as there was absolutely no instructions or even diagrams with the table. I need to cut this 3/8" steel down 3/16" deep 3.17" diameter. I know that I'm using a bit that I over heated on a side cut and maybe that's part of the problem. I'm only taking 0.003 to get a feel for...
1st Rotary Table Use - Little Help Please
1st Rotary Table Use - Little Help Please