Any one have a drawing or the measurements for the back gear shaft? Also need to know if the shaft is drilled at the same angle/ orientation on each end or are the offset holes drilled at different angles or not in line with each other at each end?
As I am reassembling my Atlas MF mill I am finding a "few" issues where some enterprising individual has (repaired???) various items on the mill. the current issue is the back gear pivot shaft, it appears to be too short, the hole for the pin to...
Atlas Mf Rebuild Help
As I am reassembling my Atlas MF mill I am finding a "few" issues where some enterprising individual has (repaired???) various items on the mill. the current issue is the back gear pivot shaft, it appears to be too short, the hole for the pin to...
Atlas Mf Rebuild Help