I HAVE BEEN USING A 6" KURT VISE ON MY PM-727M TABLE MILL .
IT DOES A GREAT JOB HOLDING THINGS STILL WHILE THEY ARE CUT TO PIECES
BUT IT IS A TAD BIG FOR THE MILL IT IS BOLTED TO .
SO I HAVE BEEN SHOPPING FOR AN AFFORDABLE USED 4" KURT AS A STABLEMATE
& I FINALLY HAVE ONE FOR THE OLD PM .
WHAT A GEM OF A WORK HOLDER THIS LITTLE GUY IS !
I CAN'T WAIT TO PUT IT TO WORK .
View attachment 121449
IT DOES A GREAT JOB HOLDING THINGS STILL WHILE THEY ARE CUT TO PIECES
BUT IT IS A TAD BIG FOR THE MILL IT IS BOLTED TO .
SO I HAVE BEEN SHOPPING FOR AN AFFORDABLE USED 4" KURT AS A STABLEMATE
& I FINALLY HAVE ONE FOR THE OLD PM .
WHAT A GEM OF A WORK HOLDER THIS LITTLE GUY IS !
I CAN'T WAIT TO PUT IT TO WORK .
View attachment 121449