The screw machine I bought has a Fanuc General Numeric GN3 control panel. The machine has Fanuc #5 DC servo motors with pulse coders. 108 volts 2000 rpm's.
I did not get any power supply's/drivers. I'm having zero luck trying to find out what all I need if I decide to put it back to original system.
Anyhow, while searching for Fanuc DC drivers, what I find are 'Velocity control units'
Are these actually DC 'drivers' or something different?
Every tid bit of info will be a great help to me....
Difference Between A Dc 'driver" & A Dc 'velocity Control Unit'?
I did not get any power supply's/drivers. I'm having zero luck trying to find out what all I need if I decide to put it back to original system.
Anyhow, while searching for Fanuc DC drivers, what I find are 'Velocity control units'
Are these actually DC 'drivers' or something different?
Every tid bit of info will be a great help to me....
Difference Between A Dc 'driver" & A Dc 'velocity Control Unit'?