hello folks, here is the situation: I have ordered a solid column riser from LMS (see the pic below) which came with some studs, but discovered that those studs are about 1/4" shorter than they need to be. There is simply not enough hight on the threads for the top nut to hold. I have measured the thread and it is metric 8 mm with 1.25 pitch. I have some O-1 drill rod in 7.5mm and I also have the thread cutting die in 8-1.25 metric.
Question: if 7.5 mm rod would be OK or do I need to get...
Making Studs For Lms Mini Mill Riser
Question: if 7.5 mm rod would be OK or do I need to get...
Making Studs For Lms Mini Mill Riser