So I did this tonight at work. It's a 3" mill vise (imported) from LMS, it was part of one of their accessory packages that I bought when I bought my mini mill. I was snugging the handle down when I heard/felt a soft 'thunk.'
Cracked it on both sides. I've been using it for about 3 months, but not daily, and definitely not improperly. I had it positioned in the middle of the table, directly under the spindle pretty much, and I had it secured with 4 clamp set-ups.
Any recommendations on...
Recommendations On A New Vise For Mini Mill...
Cracked it on both sides. I've been using it for about 3 months, but not daily, and definitely not improperly. I had it positioned in the middle of the table, directly under the spindle pretty much, and I had it secured with 4 clamp set-ups.
Any recommendations on...
Recommendations On A New Vise For Mini Mill...