I am installing a couple of used 5' x 10' MultiCam routers for a customer. I got one of them running today. Tried some air cutting just to test the system and found the Z axis was moving up on a Z minus move. I went back through and double checked everything, then read through the documentation. That's the way it's supposed to be according to MultiCam.![:cautious:]( "Cautious :cautious:")
No way to change it that I can see.
It turns out that in MultiCam's world, a Z minus move is away from the work (up in this...
Z Minus = Quill Up ???
No way to change it that I can see.It turns out that in MultiCam's world, a Z minus move is away from the work (up in this...
Z Minus = Quill Up ???