Quantcast
Channel: The Hobby-Machinist
Viewing all articles
Browse latest Browse all 83298

Chasing And An Engraving Hammer I Made

$
0
0
I must say sorry about any poor pictures again. I had a little auto focusing Canon camera,which focused on whatever it wanted to!

These were made in 1979,(one says that on the head.) And yes,one has a slipped head. But,it was not loose,just had slipped a bit during the Winter.

These are easy to make,and usually most of the work is in making the handles. You just cannot buy decent handles today at all. the idiots who design the junk that is offered today have NO sense of proper design AT...

Chasing And An Engraving Hammer I Made

Viewing all articles
Browse latest Browse all 83298

Trending Articles