Getting Ready To Bore My Pulley

Ok Im sure this is an easy project but I'm just an amateur at best... and I'm looking for some set up pointers

I have a G1008 and The previous owner put a 1 HP 56 frome motor on it. He shimmed the pulley to fit the smaller crank shaft.

Long story short the Factory bolt pattern is for a 90 Metric motor. But the pulley is 19 mm

So i have a 2HP metric motor coming 3 phase with a VFD and its got a 24mm shaft.

so i have G4003G lathe that i will be boring out the Pulley in. Just not...

Getting Ready To Bore My Pulley