I need to make a small clamp for removing the hood of an Albrecht c15 drill chuck.
The chuck is very small so the clamp is small. The depth of the hole is .103" in 1/4" thk. aluminum.
The rest of the hole is tapered like the shape of the chucks hood.
How can I make the tapered part? On a lathe? The clamp is square but I can start it with round stock then cut it into a square. The hole is .7500" dia. .103" deep. I'll have to calculate the taper.
The chuck is very small so the clamp is small. The depth of the hole is .103" in 1/4" thk. aluminum.
The rest of the hole is tapered like the shape of the chucks hood.
How can I make the tapered part? On a lathe? The clamp is square but I can start it with round stock then cut it into a square. The hole is .7500" dia. .103" deep. I'll have to calculate the taper.