I have been working diligently on the used G4003 lathe that I bought a month or so ago. I still haven't made a cut with it, but it's getting closer. I need to start a thread on the project I've made out of it (teardown, repaint, rebuild, adjustment, refinement).
Anyway, I put the 3 jaw back on it today, and spent about 4 hours studying it so far. I was surprised at the torque needed to seat the D1-4 mount. I ended up settling on 70 ft-lbs for the three square drive cam locks. At...
Torque Needed For D1-4 Cam Lock?
Anyway, I put the 3 jaw back on it today, and spent about 4 hours studying it so far. I was surprised at the torque needed to seat the D1-4 mount. I ended up settling on 70 ft-lbs for the three square drive cam locks. At...
Torque Needed For D1-4 Cam Lock?