Hi All,
After 6 grueling months of dismantling, cleaning and painting my SB is done. Upon putting
the main spindle shaft back onto the head I used the old brass shims. When I tightened down the bearing
caps the spindle would not turn(it did turn when there was no pressure applied to the bearing cap heads).
I'm assuming I need new brass shims , do I also need the laminated ones in addition.
Next question, where's a good source of supply for these(brass & laminated...
Main Spindle Shaft On Sb Heavy 10 Difficult To Turn?
After 6 grueling months of dismantling, cleaning and painting my SB is done. Upon putting
the main spindle shaft back onto the head I used the old brass shims. When I tightened down the bearing
caps the spindle would not turn(it did turn when there was no pressure applied to the bearing cap heads).
I'm assuming I need new brass shims , do I also need the laminated ones in addition.
Next question, where's a good source of supply for these(brass & laminated...
Main Spindle Shaft On Sb Heavy 10 Difficult To Turn?