I'm new to milling and just getting some hours in with the new mill. I've squared up a block and my el cheapo vise that came with the mill and things were looking good until a few hrs ago. I finished using a 3/4" end mill to face 4 sides of a 1 1/2" thick mild steel block that was 3" wide and 6" long and figured I would use the end mill to side mill the ends of the block, rather than try to stand it on end and get it square to the other surfaces. Started out ok but I noticed it was getting...
Using End Mill For Side Milling
Using End Mill For Side Milling