So, the motors I ordered have an ~8 mm shaft.
http://us.stepperonline.com/3pcs-of...motor-35a-31nm439-ozin-24hs343504d-p-398.html
The CNCFusion site says the helicals they have will only work on 1/4" shaft - not exactly ~8 mm. Is that going to be a problem? If so, is it worth sending the motors back and getting different ones?
What about this? Way less than $25 from Fusion....
Helical Couplings
http://us.stepperonline.com/3pcs-of...motor-35a-31nm439-ozin-24hs343504d-p-398.html
The CNCFusion site says the helicals they have will only work on 1/4" shaft - not exactly ~8 mm. Is that going to be a problem? If so, is it worth sending the motors back and getting different ones?
What about this? Way less than $25 from Fusion....
Helical Couplings
