I searched and didn't find a similar thread. I don't intend to duplicate.
I'm wiring a 220v 3ph lathe, and would like to wire in a 110v machine light without stretching any copper not needed.
Is it correct that I should be able to connect 1leg of the 110v light to one leg of the 220v wires, after I ensure that it is not the leg off the RPC?
However, the second leg would require additional copper wired normally to the panel, because wiring to the ground seems like a bad idea.
Is this...
110v Light Wiring On 220v 3phase Lathe?
I'm wiring a 220v 3ph lathe, and would like to wire in a 110v machine light without stretching any copper not needed.
Is it correct that I should be able to connect 1leg of the 110v light to one leg of the 220v wires, after I ensure that it is not the leg off the RPC?
However, the second leg would require additional copper wired normally to the panel, because wiring to the ground seems like a bad idea.
Is this...
110v Light Wiring On 220v 3phase Lathe?