Hi all, I need some help. (quips about my insanity are un-needed, my wife makes plenty of them)
I have a 12 inch clausing 111 lathe. It has a power crossfeed run off the lead screw, unfortunately I don't believe that I inserted the key correctly because about the third time I ran the lathe it came out and was mangled beyond recognition. So two years later now that I actually have a use for the function I have a question: how is it retained? The PDF manual I have calls it a 1/8 by 1/8...
Help Needed: Clausing 111 Power Crossfeed Key.
I have a 12 inch clausing 111 lathe. It has a power crossfeed run off the lead screw, unfortunately I don't believe that I inserted the key correctly because about the third time I ran the lathe it came out and was mangled beyond recognition. So two years later now that I actually have a use for the function I have a question: how is it retained? The PDF manual I have calls it a 1/8 by 1/8...
Help Needed: Clausing 111 Power Crossfeed Key.
